Need help?Do you have a question about the Cisco C9200L-48P-4G and is the answer not in the manual?
General| Model | C9200L-48P-4G |
|---|---|
| Category | Switch |
| Uplink Interfaces | 4 x 1G SFP |
| Switching Capacity | 176 Gbps |
| PoE Budget | 740W |
| Stacking Bandwidth | 80 Gbps |
| Enclosure Type | Rack-mountable - 1U |
| Power Over Ethernet (PoE) | Yes |
| RAM | 2 GB |
| Flash Memory | 4 GB |
| Power Device | Internal power supply |
| Voltage Required | AC 120/230 V (50/60 Hz) |
| Ports | 48 x 10/100/1000 PoE+ |
| MAC Address Table Size | 16K |
| Jumbo Frame Support | Yes |
| Routing Protocol | RIP |
| Remote Management Protocol | SNMP |
| Features | Quality of Service (QoS), VLAN support, Access Control List (ACL) support, DHCP snooping, IPv6 support |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3af, IEEE 802.3at |
| Operating Temperature | 0 to 40 °C |
| Operating Humidity | 10 to 90% non-condensing |
To Next Page