Cisco Catalyst 3650 - Page 68

Access Interface Connectivity
Configure Access Interface Connectivity
58
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
Use the show storm-control command to confirm that the interfaces are configured for storm control.
Use the show ip snooping command to confirm that the interfaces are configured for snooping.
show storm-control
Key: U - Unicast, B - Broadcast, M - Multicast
Interface Filter State Upper Lower Current Action
Type
--------- ------------- ----------- ----------- ---------- ---------
----
Gi1/0/1 Link Down 1k pps 1k pps 0 pps Trap B
Gi1/0/1 Link Down 2k pps 2k pps 0 pps Trap M
Gi1/0/2 Link Down 1k pps 1k pps 0 pps Trap B
Gi1/0/2 Link Down 2k pps 2k pps 0 pps Trap M
Gi1/0/3 Link Down 1k pps 1k pps 0 pps Trap B
Gi1/0/3 Link Down 2k pps 2k pps 0 pps Trap M
Gi1/0/4 Link Down 1k pps 1k pps 0 pps Trap B
Gi1/0/4 Link Down 2k pps 2k pps 0 pps Trap M
show ip snooping
Switch snooping is enabled
Switch gleaning is disabled
snooping is configured on following VLANs:
10-13,100
snooping is operational on following VLANs:
10-13,100
snooping is configured on the following L3 Interfaces:
Insertion of option 82 is disabled
circuit-id default format: vlan-mod-port
remote-id: 2037.0653.c800 (MAC)
Option 82 on untrusted port is not allowed
Verification of hwaddr field is enabled
Verification of giaddr field is enabled
snooping trust/rate is configured on the following Interfaces:
Interface Trusted Allow option Rate limit (pps)
----------------------- ------- ------------ ----------------
GigabitEthernet1/0/1 no no 100
Custom circuit-ids:
GigabitEthernet1/0/2 no no 100
Custom circuit-ids:
GigabitEthernet1/0/3 no no 100
Custom circuit-ids:
GigabitEthernet1/0/4 no no 100
Custom circuit-ids: