Cisco Catalyst 3750-X Message Guide

2-23
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
DOT1X Messages
Error Message DOT1X-5-ERR_TRUNK: Dot1x can not be enabled on Trunk port.
Explanation 802.1x authentication could not be enabled on the trunk port. An attempt to set 802.1x
port control to auto or force-unauthorized mode on a trunk port, which is not allowed, caused this
condition.
Recommended Action Disable trunking on the interface, and re-enable 802.1x authentication on the
port.
Error Message DOT1X-5-ERR_VLAN_INVALID: The VLAN [dec] is invalid and cannot be
assiged for use on the Dot1x port [chars] Vlan
Explanation The specified VLAN is out of range and cannot be assiged as an 802.1x port. [dec] is
the VLAN, and [chars] is the 802.1x port.
Recommended Action Reconfigure the configuration to use a valid VLAN.
Error Message DOT1X-5-FAIL: Authentication failed for client ([chars]) on Interface
[chars] AuditSessionID [chars]
Explanation The authentication was unsuccessful. The first [chars] is the client ID, the second
[chars] is the interface, and the third [chars] is the session ID.
Recommended Action No action is required.
Error Message DOT1X-5-INVALID_INPUT: Dot1x Interface parameter is Invalid on
interface [chars].
Explanation The 802.1x interface parameter is out of the specified range or is invalid. [chars] is the
interface.
Recommended Action See the command-line help string for the valid 802.1x parameters.
Error Message DOT1X-5-INVALID_MAC: Invalid MAC address(drop, zero, broadcast or
multicast mac address) [enet] is trying to authenticate.
Explanation Authentication using 802.1x is not allowed for zero, broadcast, and multicast source
MAC addresses. [enet] is the invalid MAC address.
Recommended Action Connect an 802.1x supported host to the 802.1x enabled port.
Error Message DOT1X-5-RESULT_OVERRIDE: Authentication result overridden for client
([chars]) on Interface [chars] AuditSessionID [chars]
Explanation The authentication result was overridden. The first [chars] is the client ID, the second
[chars] is the interface, and the third [chars] is the session ID.
Recommended Action No action is required.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing