Cisco Catalyst 3750-X Message Guide

2-54
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
PLATFORM Messages
Error Message PIMSN-6-IGMPSN_VLAN: PIM Snooping runtime mode on vlan [dec] [chars]
due to IGMP Snooping [chars].
Explanation When IGMP snooping is disabled, PIM snooping is disabled. When IGMP snooping is
re-enabled, PIM snooping is re-enabled. [dec] is the VLAN ID, the first [chars] is the PIM snooping
mode, and the second [chars] is the IGMP snooping mode.
Recommended Action No action is required.
PLATFORM Messages
Error Message PLATFORM-1-CRASHED: [chars].
Explanation The system is trying to display the failure message from the previous failure. [chars] is
the description of the error message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message PLATFORM-3-NO_HARDWARE_RESOURCES: Not enough hardware resources.
Shutting down [chars].
Explanation There are too many VLANs and routed ports. [chars] is the short interface name, such
as Gi1/0/1, or the VLAN name, such as VLAN0002.
Recommended Action Reduce the total number of VLANs and routed ports to be less than 1023. To
preserve configurations and connections across reboots, save the configuration.
Error Message PLATFORM-3-PW_REC_HRPC_BAD_LENGTH: Received incompatible length
(=[dec]) in set-password-recovery HRPC message from box [dec].
Note This message applies only to the Catalyst 3750-X and 3750-E switches.
Explanation The system received an incompatible length parameter in the set-password-recovery
HRPC message. This can be caused by a stack operating with incompatible software versions on
different stack members. The first [dec] is the length and the second [dec] is the switch.
Recommended Action Make sure that all stack members are running compatible software images. If the
message appears again, copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing