Cisco Catalyst 3750-X Message Guide

2-24
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
DOT1X_SWITCH Messages
Error Message DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on
Interface [chars] AuditSessionID [chars]
Explanation Authentication was successful. The first [chars] is the client ID, the second [chars] is
the interface, and the third [chars] is the session ID.
Recommended Action No action is required
DOT1X_SWITCH Messages
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars] AuditSessionID [chars]
Explanation The client MAC address could not be added to the MAC address table because the
hardware memory is full or because the address is a secure address on another port. [enet] is the
client MAC address, the first [chars] is the interface, and the second [chars] is the session ID.
Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, remove it from that port.
Note This message applies to switches running the IP base image.
Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary
VLAN [dec] to 802.1x port [chars] AuditSessionID [chars]
Explanation An attempt was made to assign a primary VLAN to an 802.1x port, which is not allowed.
[dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.
Recommended Action Use a different VLAN.
Note This message applies to switches running the IP base image.
Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid
secondary VLAN [dec] to PVLAN host 802.1x port [chars] AuditSessionID [chars]
Explanation An attempt was made to assign a nonsecondary VLAN to a private VLAN host 802.1x
port. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.
Recommended Action Change the port mode so that it is no longer a private VLAN host port, or use
a valid secondary VLAN.
Note This message applies to switches running the IP base image.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing