EasyManuals Logo

Cisco Catalyst 3750-X Message Guide

Cisco Catalyst 3750-X
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #109 background imageLoading...
Page #109 background image
2-91
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
POWERNET_ISSU Messages
Error Message PORT_SECURITY-6-VLAN_FULL: Vlan [dec] on port [chars] has reached its
limit. Address [enet] has been removed.
Explanation The voice VLAN is the same as the access VLAN. Because the maximum number of
MAC addresses allowed on the access VLAN has been reached, the specified Ethernet address has
been deleted. [dec] is the VLAN ID, [chars] is the port assigned to the voice VLAN and the access
VLAN, and [enet] is the Ethernet address.
Recommended Action No action is required.
Error Message PORT_SECURITY-6-VLAN_REMOVED: VLAN [int] is no longer allowed on port
[chars]. Its port security configuration has been removed.
Explanation A configured VLAN is not allowed either due to a port mode change or an allowed
VLAN list change and is removed from the configuration. [int] is the VLAN ID, and [chars] is the
switch port assigned to the VLAN.
Recommended Action No action is required.
POWERNET_ISSU Messages
Error Message POWERNET_ISSU-4-SM_EW_DOMAIN_MISMATCH: Energywise domain of
EtherSwitch is [chars], recommended to have [chars].
Explanation The EnergyWise domain of the service module does not match that of the switch. The
first [chars] is the EnergyWise domain of the service module. The second [chars] is the EnergyWise
domain of the router.
Recommended Action Configure the EnergyWise domain of the service module to match that of the
switch. If the message recurs, copy the message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit
to look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information.
Note This message applies only to the Catalyst 3750-X and 3560-X switches.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals