2-109
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
STORM_CONTROL Messages
Error Message STACKMGR-4-SWITCH_REMOVED: Switch [dec] has been REMOVED from the
stack.
Explanation The specified switch has been removed from the stack. [dec] is the switch number.
Recommended Action No action is required.
Error Message STACKMGR-5-MASTER_READY: Master Switch [dec] is READY.
Explanation The stack master is ready for use. [dec] is the stack master switch number.
Recommended Action No action is required.
Error Message STACKMGR-5-SWITCH_READY: Switch [dec] is READY.
Explanation The switch is ready. [dec] is the switch number.
Recommended Action No action is required.
STORM_CONTROL Messages
Error Message STORM_CONTROL-3-FILTERED: A [chars] storm detected on [chars]. A
packet filter action has been applied on the interface.
Explanation The amount of traffic detected on the interface has exceeded the configured threshold
values. The system is filtering the excess traffic. The first [chars] is the traffic type, and the second
[chars] is the interface.
Recommended Action Determine and fix the root cause of the excessive traffic on the interface.
Error Message STORM_CONTROL-3-SHUTDOWN: A packet storm was detected on [chars]. The
interface has been disabled.
Explanation The amount of traffic detected on the interface has exceeded the configured threshold
values. Because the interface is configured to shut down if a packet storm event is detected, it has
been placed in an error-disabled state. [chars] is the affected interface.
Recommended Action You can enable error-disabled recovery by using the errdisable recovery
global configuration command to automatically re-enable the interface. You should determine and
fix the root cause of the excessive traffic on the interface.
To Next Page
Loading...
Need help?
General
