Cisco Catalyst 3750-X Message Guide

2-125
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
UFAST_MCAST_SW Messages
UFAST_MCAST_SW Messages
Error Message UFAST_MCAST_SW-3-PROC_START_ERROR: No process available for
transmitting UplinkFast packets.
Explanation UplinkFast packets will not be sent because the process could not be created.
Recommended Action UplinkFast does not work unless you reload the switch software. If the message
appears again after reload, copy the message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit
to look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message UFAST_MCAST_SW-4-MEM_NOT_AVAILABLE: No memory is available for
transmitting UplinkFast packets on Vlan [dec].
Explanation UplinkFast packets will not be sent on a VLAN due to memory limitations. [dec] is the
VLAN ID.
Recommended Action Reduce other system activity to ease memory demands.
VQPCLIENT Messages
Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP.
Explanation An error occurred when the system tried to allocate memory for the VQP client.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars].
Explanation The VMPS has denied access for the given host MAC address to an interface. [enet] is
the host MAC address, and [chars] is the interface name.
Recommended Action No action is normally required. If you think that the host should have been
allowed access, verify the configuration on the VMPS.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing