Cisco Catalyst 3750-X Message Guide

2-31
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
EC Messages
Error Message EC-5-ERRPROT: Channel protocol mismatch for interface [chars] in group
[dec]: the interface can not be added to the channel group.
Explanation The interface cannot be added to the channel group with the specified mode. [chars] is
the interface, and [dec] is the channel group.
Recommended Action Change the channel group or the mode for the interface.
Error Message EC-5-ERRPROT2: Command rejected: the interface [chars] is already part
of a channel with a different type of protocol enabled.
Explanation The interface cannot be selected for the specified protocol because it is already part of
a channel with a different protocol. [chars] is the interface.
Recommended Action Remove the interface from the channel group.
Error Message EC-5-ERRPROT3: Command rejected: the interface [chars] is already part
of a channel.
Explanation The interface cannot be unselected for the specified protocol because it is already part
of a channel group. [chars] is the interface.
Recommended Action Remove the interface from the channel group.
Error Message EC-5-L3DONTBNDL1: [chars] suspended: PAgP not enabled on the remote
port.
Explanation PAgP is enabled on the Layer 3 interface but the partner port is not enabled for PAgP.
In this mode, the port is placed in a suspended state. [chars] is the Layer 3 interface.
Recommended Action Enable PAgP on the remote side by using the channel-group interface
configuration command.
Error Message EC-5-L3DONTBNDL2: [chars] suspended: LACP currently not enabled on the
remote port.
Explanation LACP is enabled on a Layer 3 interface but is not enabled on the partner port. In this
mode, the port is put in a suspended state. [chars] is the interface name.
Recommended Action Enable LACP on the remote side.
Error Message EC-5-L3DONTBNDL3: [chars] suspended: LACP not enabled on the remote
port.
Explanation LACP is enabled on a Layer 3 interface but the remote port does not have LACP
enabled. In this mode, the local port is put in a suspended state. [chars] is the interface name.
Recommended Action Enable LACP on the remote port.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing