EasyManuals Logo

Cisco Catalyst 3750-X Message Guide

Cisco Catalyst 3750-X
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
2-41
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
HARDWARE Messages
Error Message HARDWARE-3-PORTNUM_ERROR: [traceback] port number [dec] is invalid
Explanation The port number is out of range. [dec] is the port number.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information.
Error Message HARDWARE-3-THERMAL_NOT_FUNCTIONING: Temperature Sensor is not
functioning.
Explanation The temperature sensor is not functioning, and the switch temperature behavior cannot
be determined.
Recommended Action Ensure that the ambient temperature is not too high. If the message appears
again, replace the component.
Error Message HARDWARE-3-STATS_ERROR: Statistics ID [dec] is invalid.
Explanation The statistics ID used is out of range. The statistics supported by the port ASIC are
identified by an ID. [dec] is the statistics ID.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message HARDWARE-5-FAN_NOT_PRESENT: Fan is not present.
Explanation The fan is not in the switch.
Recommended Action Make sure the fan is completely inserted. If the fan is removable, remove and
replace it into the switch. If the message appears again after insertion, replace the fan.
Error Message HARDWARE-5-FAN_OK: Fan works fine.
Explanation The fan is now working properly.
Recommended Action No action is required.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals