Cisco Catalyst 3750-X

2-48
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
ILPOWER Messages
Error Message ILPOWER-5-IEEE-DISCONNECT: Interface [chars]: PD removed.
Explanation The powered device is not connected to the switch, or the connected powered device is
being powered by an external AC power source. The switch is no longer providing power to the port.
[chars] is the interface.
Recommended Action No action is required.
Error Message ILPOWER-5-ILPOWER_POWER_CDP_SHUT: Interface [chars]: inline power shut
Explanation Inline power is shut down because CDP consumption power on this PoE port is greater
than the allocation power, the hardware interface limit, the user-configured maximum power, or the
available power on this switch. [chars] is the interface.
Recommended Action No action is required.
Error Message ILPOWER-5-ILPOWER_POWER_DENY: Interface [chars]: inline power denied.
Explanation There is not enough power remaining in the switch to supply to the PoE port. [chars] is
the interface.
Recommended Action Connect the powered device to an external AC power source.
Error Message ILPOWER-5-INVALID_IEEE_CLASS: Interface [chars]: has detected invalid
IEEE class: [dec] device. Power denied
Explanation The powered device has an invalid IEEE class so that the switch is not providing power
to the device. [chars] is the interface. [dec] is the IEEE class number.
Recommended Action No action is required.
Error Message ILPOWER-5-LINKDOWN_DISCONNECT: Interface [chars]: Link down
disconnect.
Explanation The powered device is no longer connected to the switch, or the connected powered
device is being powered by an external AC power source. The switch is no longer providing power
on the interface. [chars] is the interface.
Recommended Action No action is required.
Error Message ILPOWER-5-POLICE_POWER_INVALID: Interface [chars]: invalid power
police [dec] milliwatts current [dec] mA voltage [dec] mV
Explanation The power policing current or voltage value is invalid. [chars] is the interface. The first
[dec] is the power policing limit (cutoff value in mW), the second [dec] is the power usage in mA,
and the third [dec] is the power usage in mV.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or