Cisco Catalyst 3750-X Message Guide

2-71
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
PLATFORM_STACKPOWER Messages
Error Message PLATFORM_STACKPOWER-4-VERSION_MISMATCH: Major version mismatch in
stack power protocol message on switch [dec]
Explanation A version mismatch exists between the switch and the other stack members. [dec] is the
stack member number.
Recommended Action Ensure that all switches in the power stack are running the same Cisco IOS
software release.
Error Message PLATFORM_STACKPOWER-3-INVALID_TOPOLOGY: Invalid power stack topology
observed by switch [dec] [chars]
Explanation The power stack topology is invalid. The switch is forced into standalone mode.
[dec] is the stack member number. [chars] is a number that explains the reason for the invalid power
stack topology.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message PLATFORM_STACKPOWER-4-POWER_BUDGET: Switch [dec] power budget is at
least 1000W greater than its local supplies
Explanation The power budget of the switch is more than 1000 W above the rated power output for
the switch stack’s power supplies. Add another power supply to the switch stack. [dec] is the stack
member number.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Error Message PLATFORM_STACKPOWER-4-CABLE_A_CURRENT_IN: Switch [dec] stack power
cable 1 inward current is over the limit
Explanation Power cable 1 of the switch stack has an inward current that is over 40 A. Add another
power supply to the switch stack. [dec] is the stack member number.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing