CHAPTER 2
Preparing for Installation
•
Safety Warnings, page 13
•
Site Requirements, page 14
•
Power Requirements, page 23
•
Cabling Requirements, page 24
•
Rack-Mounting Guidelines, page 24
•
Site Preparation Checklist, page 25
Safety Warnings
Safety warnings appear throughout this publication in procedures that may harm you if you perform them
incorrectly. A warning symbol precedes each warning statement. The warnings below are general warnings
that are applicable to the entire publication.
Read the installation instructions before connecting the system to the power source. Statement 1004Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 250 V, 20 A. Statement 1005
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key or other means of security. Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
OL-30656-01 13
To Next Page
Loading...
