Cisco Catalyst 6807-XL User Manual

supervisor engine, the Layer 2 addresses of all the ports change to those specified in the address allocator on
the new supervisor engine.
Removing and Installing Power Supplies
This section describes how to remove and install PSMs.
Note
•
The PSMs installed in the switch chassis should be AC input only.
•
The PSM is designed to be removed and replaced while the system is operating without presenting
an electrical hazard or damage to the system.
Use both hands to install and remove power supplies.Caution
Related Topics
Power Supply Module, on page 5
Power Entry Module, on page 7
Power Supply Module LEDs, on page 9
3000 W Power Supply AC Power Cords, on page 67
Installing AC Power Supplies
To install an AC input PSM, follow these steps:
High leakage current-earth connection essential before connecting to system power supply. Statement 342Warning
Before You Begin
•
For ground connection instructions, see Establishing System Ground, on page 41
•
You may require a flat-blade or Number 2 Phillips-head screwdriver to tighten the screw on the PSM.
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
50 OL-30656-01
Removing and Replacing FRUs
Removing and Installing Power Supplies

Cisco Catalyst 6807-XL Specifications

General

Brand	Cisco
Model	Catalyst 6807-XL
Category	Switch
Language	English