Procedure
Step 1
Locate the fan tray in the chassis.
Step 2
Grasp and simultaneously push both spring latches with your thumb in a left to right direction. Slide the fan
tray half-way out of the bay. Rock it gently, if necessary, to unseat the power connector from the backplane.
Figure 17: Fan Tray Location and Spring Latch Operation
Fan tray LED3Spring latches and close-up view of spring
latch operation
1
Fan tray handle2
Step 3
Grasp the handle to pull the fan assembly clear of the chassis, and set it aside.
Cisco Catalyst 6807-XL Switch Hardware Installation Guide
56 OL-30656-01
Removing and Replacing FRUs
Removing the Fan Tray
To Next Page
Loading...
