Slotted holes for hose clamps2
Installing the Antenna
You can install the antenna on a wall or ceiling (must be a flat surface) or on a pole with a minimum diameter
of 2 inches (5.08 cm) and a maximum diameter of 5 inches (12.7 cm).
Procedure
Step 1 Decide on a mounting location.
See Deciding on a Mounting Location, on page 12.
Step 2 Ensure that you have the required tools and fasteners ready
See Required Tools and Equipment, on page 13.
Step 3 Proceed with mounting the antenna.
When mounting the antenna:
a. Assemble the bracket hardware.
b. Connect the antenna and the bracket to the mounting surface.
c. Secure the antenna using the tether anchor (tether strap not included).
d. Connect the antenna to ground using the included ground screw and Electrical Joint Compound.
e. Adjust the antenna orientation.
The mounting options available are:
• Mounting on a Wall or Ceiling Using Articulating Bracket, on page 14
• Mounting on a Pole or Mast
Step 4 (Optional) Paint the antenna.
See Painting the Antenna, on page 22.
Step 5 Install a Solar Shield.
See Installing the Solar Shield, on page 23.
Deciding on a Mounting Location
The antenna should be mounted clear of any obstructions to the side or front of the enclosure, which contains
the radiating elements. Remember to aim this antenna at the intended coverage area. Therefore, you should
mount the antenna and adjust it to achieve the desired mechanical tilt.
Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
12
Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
Installing the Antenna
To Next Page
Loading...
Need help?
General
