Name: Cisco Catalyst C9300-48P
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

To remove a StackWise-320 adapter from the connector, make sure you press down the spring latch to unlock

it from the slot.

Removing and installing the StackWise cable can shorten its useful life. Do not remove and insert the cable

more often than is absolutely necessary (installing and removing it up to 200 times is supported).

Step 5 Connect the other end of the cable to the StackWise port on the other switch.

Connecting a StackWise-480/1T Cable

Procedure

Step 1 Remove the dust covers from the StackWise cables and store them for future use.

Step 2 Connect the cable to the StackWise port on the switch rear panel. Align the connector and connect the StackWise

cable to the StackWise port on the switch rear panel and finger-tighten the screws (clockwise direction). Make

sure the Cisco logo is on the top side of the connector as shown in the figure.

Cisco Catalyst 9300 Series Switches Hardware Installation Guide

Installing a Switch

Connecting a StackWise-480/1T Cable

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst C9300-48P and is the answer not in the manual?

Cisco Catalyst C9300-48P Specifications

General