Cisco Catalyst IR1800 Rugged Series - Connecting the Router; Connection Process and Preparation

guidelines are based on IEEE ANSI C 95.1 and include a substantial safety margin designed to ensure the
safety of all persons, regardless of age and health.
As such the systems are designed to be operated as to avoid contact with the antennas by the end user. It is
recommended to set the system in a location where the antennas can remain at least a minimum distance as
specified from the user in accordance to the regulatory guidelines which are designed to reduce the overall
exposure of the user or operator.
The device has been tested and found compliant with the applicable regulations as part of the radio certification
process.
The US Food and Drug Administration has stated that present scientific information does not indicate the
need for any special precautions for the use of wireless devices. The FCC recommends that if you are interested
in further reducing your exposure then you can easily do so by reorienting antennas away from the user or
placing the antennas at a greater separation distance then recommended or lowering the transmitter power
output.
As per FCC ecfr 2.1091 & 2.1093 exempt criteria, Single Transmissions are exempted from the RF Exposure
calculation. The calculation considered 100% Duty cycle for all Simultaneous Transmission technology. The
RF Exposure Calculation is without compensating Cable and connector losses. The RF Exposure calculation
is with highest supported antenna gain.
Note
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 30cm between the radiator and your body.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
This Device Meets the Industry Canada Guidelines for Exposure to Radio
Waves
The IR1800 series includes a radio transmitter and receiver. It is designed not to exceed the limits for exposure
to radio waves (radio frequency electromagnetic fields) as referenced in Health Canada Safety Code 6. The
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
83
Regulatory Compliance
FCC Radiation Exposure Statement