Cisco Catalyst IW9165D User Manual

MeaningColorLED Message Type
Configuration recovery is in progress (the Reset button
has been pushed for 2 to 3 seconds)
Blinking RedBoot loader warnings
There is an Ethernet failure or an image recovery (the
Reset button has been pushed for 20-30 seconds)
Solid Red
Image recovery is in progress (the Reset button has been
released)
Blinking Green
Cisco URWB OS
In the state of requesting IP address from DHCP server.Flashing (short blips)
Amber
Limbo (Provisioning)
mode: Fallback
This status indicates that the IP address is retrieved from
DHCP server.
AmberLimbo (Provisioning)
mode: DHCP
Using the Reset Button
Using the Reset button (see Connectors and Ports, on page 2), you can reset the AP to factory default or
clear the AP's internal storage.
To reset the AP to the default factory-shipped configuration, perform the following steps:
Step 1 Press, and continue to press the Reset button on the access point during the AP boot cycle.
Step 2 The AP status LED will turn red once the timer has started. Continue to hold the Reset button for more than 20 seconds,
but less than 60 seconds. The following will happen:
• The AP status LED changes to solid red.
• All the files in the AP storage directory are cleared.
• A full factory reset is triggered.
• The FIPS mode flag is also cleared during the full factory reset of the AP. If the FIPS flag is set, the console access
is disabled.
If you keep the Reset button pressed for more than 60 seconds, the button is assumed as being faulty and no
changes are made.
Note
Cisco Catalyst IW9165D Heavy Duty Access Point Hardware Installation Guide
38
Troubleshooting
Using the Reset Button

Cisco Catalyst IW9165D Specifications

General

Brand	Cisco
Model	Catalyst IW9165D
Category	Wireless Access Point
Language	English