CHAPTER 5
Safety Guidelines and Warnings
• Safety Instructions, on page 39
• FCC Safety Compliance Statement, on page 40
• Safety Precautions, on page 40
• Safety Precautions when Installing Antennas, on page 41
• Avoiding Damage to Radios in a Testing Environment, on page 41
• Performing Site Surveys, on page 42
Safety Instructions
The translated warnings are available in the Translated Safety Warnings for Cisco Catalyst Access Points,
which is available on Cisco.com.
IMPORTANT SAFETY INSTRUCTIONSThis warning symbol means danger. You are in a situation
that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved
with electrical circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device.SAVE THESE INSTRUCTIONS Statement 1071
Warning
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Cisco Catalyst IW9165D Heavy Duty Access Point Hardware Installation Guide
39
To Next Page
Loading...
Need help?
General
