Cisco CRS-1 - Carrier Routing System Router Migration Guide

3-35
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Input total packets = 1000
Input 802.1Q frames = 0
Input pause frames = 0
Input pkts 64 bytes = 1000
Input pkts 65-127 bytes = 0
Input pkts 128-255 bytes = 0
Input pkts 256-511 bytes = 0
Input pkts 512-1023 bytes = 0
Input pkts 1024-1518 bytes = 0
Input pkts 1519-Max bytes = 0
Input good pkts = 1000
Input unicast pkts = 0
Input multicast pkts = 1000
Input broadcast pkts = 0
Input drop overrun = 0
Example: show controllers GigabitEthernet Command
RP/0/RSP0/CPU0:Router# show controllers GigabitEthernet 0/0/0/1
Operational data for interface GigabitEthernet0/0/0/1:
State:
Administrative state: enabled
Operational state: Up
LED state: Green On
Media:
Media type: X fiber over short-wl laser PMD, full duplex
Optics:
Vendor: CISCO-FINISAR
Part number: FTLF8519P2BNL-C6
Serial number: FNS120304T9
MAC address information:
Operational address: 001d.e5eb.88e1
Burnt-in address: 001d.e5eb.88e1
No unicast addresses in filter
No multicast addresses in filter
Autonegotiation enabled:
No restricted parameters
Operational values:
Speed: 1Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
MTU: 1526
MRU: 1526
Inter-packet gap: standard (12)
Example: show controllers TenGigE Command
The following example shows the output from the show controllers TenGigE command for the
Cisco
8-Port 10-Gigabit Ethernet physical layer interface module (PLIM):
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/3/0/0
PHY:
XENPAK device registers:
========================
Vendor Name: CISCO-INTEL
Vendor PN: TXN174112013F06

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English