Cisco CRS-1 - Carrier Routing System Router Migration Guide

3-34
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Example: show controllers GigabitEthernet Command
The following example shows the output from the show controllers GigabitEthernet command:
RP/0/RSP0/CPU0:Router# show controllers GigabitEthernet 0/1/0/1
Statistics for interface GigabitEthernet0/1/0/0 (cached values):
Ingress:
Input total bytes = 64000
Input good bytes = 64000
GOPIntCause0 Register that tracks all GOP interrupts and matches them with the
GOP0 register.
GOPIntMask1 GOP interrupt Mask1. When the matching bit in the mask register
is reset, the matching cause in the GOP register is not included in
the sum.
GOPIntCause1 Register that tracks all GOP interrupts and matches them with the
Mask1 register.
GOPIntMask2 GOP interrupt Mask2. When the matching bit in the mask register
is reset, the matching cause in the GOP register is not included in
the sum.
GOPIntCause2 Register that tracks all GOP interrupts and matches them with the
Mask2 register.
GOPIntMask3 GOP interrupt Mask3. When the matching bit in the mask register
is reset, the matching cause in the GOP register is not included in
the sum.
GOPIntCause3 Register that tracks all GOP interrupts and matches them with the
Mask3 register.
CalendarParam Register that determines the value of Calendar_LEN and Calendar
M for the sink and source side.
SPI4SrcDPDeskew Register used to control the training pattern generation on the
source side.
SrcClndrCmd Register used to program the CALENDAR slots in the calendar
report generated by the device.
SnkCalSeqPrgm Register used to program the CALENDAR slots in the calendar
report generated by the device.
SinkControl Register used to control the operation of the SPI-4.2 SINK section.
SPI4SrcMaxBrst Register used to determine the system parameters MaxBurst1 and
MaxBurst2 on the source side. These values are used by the internal
packet scheduler to initiate bursts on the SP-4.2 Rx interface.
SPI4IntfBrstLen Register used to determine the actual length of the data bursts on the
SP-4.2 physical interfaces. These values are different than the
system parameters MaxBurts1/2, which corresponds to SP-4.2 flow
control.
TxPacketSize Maximum transmit packet size for the port, in hexadecimal format.
RxFullWatermarks Determines the internal RxFIFO full thresholds.
RxFIFOXOnOffFCWtrmrk Determines the generation of 802.3x PAUSE frames based on
RxFIFO data fill thresholds.
Table 7 show controllers GigabitEthernet Field Descriptions
Field Description

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English