EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-45
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
MII_MGMT_ADDRESS (#1041): 00000000
MII_MGMT_DATA (#1042): 40000000
STAT_CONFIG (#1043): 00000007
MASK_R (#1044): 00000000
MASK_T (#1045): 00000000
COMP (#1046): 00100d24
MAC_CONFIG (#1047): ffffffff
INTERRUPT_C (#1048): 00000002
RP/0/RSP0/CPU0:Router# show controllers TenGigE 0/4/0/0 all
Operational data for interface TenGigE0/4/0/0:
State:
Administrative state: enabled
Operational state: Up
LED state: Green On
Media:
Media type: R fiber over 1310nm optics
Optics:
Vendor: CISCO-OPNEXT
Part number: TRF5012AN-LA000
Serial number: ONT1207108S
MAC address information:
Operational address: 001b.53ff.a780
Burnt-in address: 001b.53ff.a780
No unicast addresses in filter
No multicast addresses in filter
Autonegotiation disabled.
Operational values:
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
MTU: 9112
MRU: 9112
Inter-packet gap: standard (12)
BERT status for TenGigE0/4/0/0:
BERT State : DISABLED
Test Pattern : None test pattern
Time Remaining : 0
Time Interval : 0
Statistics for interface TenGigE0/4/0/0 (cached values):
Ingress:
Input total bytes = 9617267341
Input good bytes = 9617267341
Input total packets = 106745913
Input 802.1Q frames = 0
Input pause frames = 0
Input pkts 64 bytes = 103938714
Input pkts 65-127 bytes = 2494947
Input pkts 128-255 bytes = 3411
Input pkts 256-511 bytes = 3407
Input pkts 512-1023 bytes = 2
Input pkts 1024-1518 bytes = 0
Input pkts 1519-Max bytes = 305432

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals