EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-46
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Input good pkts = 106745913
Input unicast pkts = 105659161
Input multicast pkts = 1086750
Input broadcast pkts = 2
Input drop overrun = 0
Input drop abort = 0
Input drop unknown 802.1Q = 0
Input drop other = 0
Input error giant = 0
Input error runt = 0
Input error jabbers = 0
Input error fragments = 0
Input error CRC = 0
Input error collisions = 0
Input error symbol = 0
Input error other = 0
Input MIB giant = 305432
Input MIB jabber = 0
Input MIB CRC = 0
Egress:
Output total bytes = 15207323765
Output good bytes = 15207323765
Output total packets = 107567467
Output 802.1Q frames = 0
Output pause frames = 0
Output pkts 64 bytes = 103894198
Output pkts 65-127 bytes = 2448807
Output pkts 128-255 bytes = 308809
Output pkts 256-511 bytes = 6
Output pkts 512-1023 bytes = 13
Output pkts 1024-1518 bytes = 0
Output pkts 1519-Max bytes = 915634
Output good pkts = 107567467
Output unicast pkts = 105353061
Output multicast pkts = 1298771
Output broadcast pkts = 1
Output drop underrun = 0
Output drop abort = 0
Output drop other = 0
Output error other = 0
Management information for interface TenGigE0/4/0/0:
Port number: 0
Bay number: 0
Interface handle: 0xc000040
Config:
Auto-negotiation: Configuration not supported (Off)
Carrier delay (up): Not configured
Carrier delay (down): Not configured
Speed: Configuration not supported (10Gbps)
Duplex: Configuration not supported (Full Duplex)
Flow Control: Not configured (None)
IPG: Not configured (standard (12))

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals