Cisco CRS-1 - Carrier Routing System Router

3-47
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Loopback: Not configured (None)
MTU: 9100 bytes
Soft Bandwidth: Not configured
Driver constraints:
Min MTU: 64 bytes
Max MTU: 9216 bytes
Max speed: 10Gbps
Interface type: TenGigE
Management interface: No
Promiscuous mode: Yes
Allowed config mask: 0x27b
Cached driver state:
MTU: 9108 bytes
Burnt-in MAC address: 001b.53ff.a780
Bundle settings:
Aggregated: No
Bundle MTU: 1514 bytes
Bundle MAC address: 001b.53ff.a780
Port FSM state:
Port is enabled, link is up
Complete FSM state:
Admin up
Bundle admin up
Client admin up
Client admin tx not disabled
Port enabled
Port tx enabled
Hardware link up
IDB interface state information:
IDB bundle admin up
IDB client admin up
IDB client tx admin up
IDB error disable not set
0 Unicast MAC Addresses:
0 Multicast MAC Addresses:
0 Unicast Bundle MAC Addresses:
0 Multicast Bundle MAC Addresses:
Current Data
NP(03) Version : 0003
Structure Version : 2582
XAUI Interface : B
MAC addr : 00.1b.53.ff.a7.80
RX enabled : True
TX enabled : True
Obey Pause Frames : False
TX Pause Frames : False
Pause Re-TX Period : 3000000
Min Frame Len : 60
Max Frame Len : 9112
Ignore Errors : False
Add CRC : True
Strip CRC : True
Ignore CRC Errors : False
DMA Add CRC : False