3-52
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Carrier delay (down): Not configured
Speed: Configuration not supported (10Gbps)
Duplex: Configuration not supported (Full Duplex)
Flow Control: Not configured (None)
IPG: Not configured (standard (12))
Loopback: Not configured (None)
MTU: Not configured
Bandwidth: Not configured --> This output field is changed
BER-SD Threshold: Configuration not supported --> These BER output fields are new
BER-SD Report: Configuration not supported
BER-SF Threshold: Configuration not supported
BER-SF Report: Configuration not supported
BER-SF Signal Remote Failure: Configuration not supported
Driver constraints:
Min MTU: 64 bytes
Max MTU: 9600 bytes
Max speed: 10Gbps
Interface type: TenGigE
Management interface: No
Promiscuous mode: Yes
Default carrier delay up (auto-neg on): 0 ms --> This field is new
Default carrier delay down (auto-neg on): 0 ms --> This field is new
Default carrier delay up (auto-neg off): 0 ms --> This field is new
Default carrier delay down (auto-neg off): 0 ms --> This field is new
Allowed config mask: 0x27b
Cached driver state:
MTU: 1522 bytes
Burnt-in MAC address: 0014.f294.6776
Operational carrier delay: --> This section is new
Carrier delay (up): 0 ms
Carrier delay (down): 0 ms
Bundle settings:
Aggregated: No
Bundle MTU: 1514 bytes
Bundle MAC address: 0014.f294.6776
Port FSM state:
Port is disabled, due to an admin down condition.
Complete FSM state:
Admin down
Bundle admin up
Client admin up
Client admin tx not disabled
Port disabled
Port tx disabled
Hardware link down
IDB interface state information:
IDB bundle admin up
IDB client admin up
IDB client tx admin up
IDB error disable not set
0 Unicast MAC Addresses:
0 Multicast MAC Addresses:
0 Unicast Bundle MAC Addresses:
0 Multicast Bundle MAC Addresses:
To Next Page
Loading...
