3-53
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Operational address: 0014.f294.6776 --> The rest of this output appears to be new
Burnt-in address: 0014.f294.6776
PLA 0 port 0 MAC enabled Rx MAC disabled
Administrative state: Forced Remote fault
Operational state: Remote fault
0 HSRP/VRRP MAC addresses
VLAN Ethertype: 0x8100
QinQ Ethertype: 0x88a8
MTP Ethertype: 0x88e7
4 VLAN UIDB entries
VLAN1 VLAN2 Packet Type Flags UIDB Result Flags
0 0 VLAN 1 VLAN
0 0 ARPA 1 ARPA
0 0 SAP 1 SAP
0 0 1 SNAP
Total Power Available on PLIM for XFP's: 35000 mW
Power used by Inserted XFP's: 33000 mW
Power Available: 2000 mW
Port Power Used State
00 2500 mW XFP Inserted and Powered On
01 2500 mW XFP Inserted and Powered On
02 1500 mW XFP Inserted and Powered On
03 2500 mW XFP Inserted and Powered On
04 2500 mW XFP Inserted and Powered On
05 1500 mW XFP Inserted and Powered On
06 2500 mW XFP Inserted and Powered On
07 2500 mW XFP Inserted and Powered On
08 2500 mW XFP Inserted and Powered On
09 2500 mW XFP Inserted and Powered On
10 2500 mW XFP Inserted and Powered On
11 2500 mW XFP Inserted and Powered On
12 2500 mW XFP Inserted and Powered On
13 2500 mW XFP Inserted and Powered On
802.3ae Sections
================
PMA/PMD
Previous Alarm Status:
PMA/PMD NOT Locked to Local Signal
Current Alarm Status:
PMA/PMD NOT Locked to Local Signal
PMA/PMD Local Fault
SR Ability
Loopback Ability
Rx Local Fault
PCS
Previous Alarm Status:
PCS Rx Link DOWN
PCS Rx NOT Block Locked
PCS Rx Link Status DOWN
PCS Error'd Block Counts: 0
PCS BER Counts: 0
PCS has NO Block Lock
Current Alarm Status:
To Next Page
Loading...
