EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router - Page 220

Cisco CRS-1 - Carrier Routing System Router
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-60
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
Port Number : 0
Port Type : 10GE
Transport mode : LAN
BIA MAC addr : 001b.53ff.a780
Oper. MAC addr : 001b.53ff.a780
Port Available : true
Status polling is : enabled
Status events are : enabled
I/F Handle : 0x0c000040
Cfg Link Enabled : tx/rx enabled
H/W Tx Enable : yes
MTU : 9112
H/W Speed : 10 Gbps
H/W Duplex : Full
H/W Loopback Type : None
H/W FlowCtrl type : None
H/W AutoNeg Enable: Off
H/W Link Defects : (0x0000) None
Link Up : yes
Link Led Status : Link up
Symbol errors : 255
Serdes version : 14.42
Input good underflow : 0
Input ucast underflow : 0
Output ucast underflow : 0
Input unknown opcode underflow: 0
Pluggable Present : yes
Pluggable Type : 10GBASE-LR
Pluggable Compl. : Compliant
Pluggable Type Supp.: Supported
Pluggable PID Supp. : Supported
Pluggable Scan Flg: false
The following example shows sample output for the show controllers TenGigE internal command for
the Cisco
CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0 internal
Thu Oct 7 18:27:01.022 EST
Total Power Available on PLIM for XFP's: 35000 mW
Power used by Inserted XFP's: 33000 mW
Power Available: 2000 mW
Port Power Used State
00 2500 mW XFP Inserted and Powered On
01 2500 mW XFP Inserted and Powered On
02 1500 mW XFP Inserted and Powered On
03 2500 mW XFP Inserted and Powered On
04 2500 mW XFP Inserted and Powered On
05 1500 mW XFP Inserted and Powered On
06 2500 mW XFP Inserted and Powered On
07 2500 mW XFP Inserted and Powered On
08 2500 mW XFP Inserted and Powered On
09 2500 mW XFP Inserted and Powered On
10 2500 mW XFP Inserted and Powered On
11 2500 mW XFP Inserted and Powered On
12 2500 mW XFP Inserted and Powered On
13 2500 mW XFP Inserted and Powered On
Example: show controllers TenGigE mac Command
The following example shows sample output for the show controllers TenGigE mac command for the
Cisco
CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals