Cisco CRS-1 - Carrier Routing System Router - CHAPTER 8 Managing the Cisco CRS System

3-61
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers (Ethernet)
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0 mac
Thu Oct 7 18:27:34.289 EST
Operational address: 0014.f294.6776
Burnt-in address: 0014.f294.6776
PLA 0 port 0 MAC enabled Rx MAC disabled
Administrative state: Forced Remote fault
Operational state: Remote fault
0 HSRP/VRRP MAC addresses
VLAN Ethertype: 0x8100
QinQ Ethertype: 0x88a8
MTP Ethertype: 0x88e7
4 VLAN UIDB entries
VLAN1 VLAN2 Packet Type Flags UIDB Result Flags
0 0 VLAN 1 VLAN
0 0 ARPA 1 ARPA
0 0 SAP 1 SAP
0 0 1 SNAP
Example: show controllers TenGigE phy Command
The following example shows sample output for the show controllers TenGigE phy command for the
Cisco
CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:router#show controllers TenGigE 0/1/0/0 phy
Thu Oct 7 18:27:51.884 EST
802.3ae Sections
================
PMA/PMD
Previous Alarm Status:
PMA/PMD NOT Locked to Local Signal
PMA/PMD Local Fault
SR Ability
Loopback Ability
Rx Local Fault
Current Alarm Status:
PMA/PMD NOT Locked to Local Signal
PMA/PMD Local Fault
SR Ability
Loopback Ability
Rx Local Fault
PCS
Previous Alarm Status:
PCS Rx Link DOWN
PCS Local Fault Detected
PCS Rx Local Fault Detected
PCS Rx NOT Block Locked
PCS Rx Link Status DOWN
PCS Error'd Block Counts: 0
PCS BER Counts: 0
PCS has NO Block Lock
Current Alarm Status:
PCS Rx Link DOWN
PCS Local Fault Detected
PCS Rx Local Fault Detected
PCS Rx NOT Block Locked
PCS Rx Link Status DOWN