Cisco CRS

Task ID
OperationTask ID
read, writeroot-lr
Examples
This example shows how to set the police rate deviation tolerance to 8% on the output interface at location
0/1/CPU0:
RP/0/RP0/CPU0:router(config)# hw-module qos output police granularity 8 location 0/1/CPU0
Examples
This example demonstrates how a default police rate deviation tolerance of 2% is configured on an interface,
when the police-rate-dev-tol argument is not specified. After performing this configuration step, a police
rate deviation tolerance of 2% is applied on the output interface at location 0/1/CPU0:
RP/0/RP0/CPU0:router(config)# hw-module qos output police granularity location 0/1/CPU0
Related Commands
DescriptionCommand
Displays the police granularity information for output
interfaces.
show hw-module qos output police granularity
location, on page 121
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 29
Quality of Service Commands on the Cisco IOS XR Software
hw-module qos output police granularity location