Cisco CRS

Examples
The following example shows how to specify a class map called map1 and configures map1 to be used as the
match criteria for this class:
RP/0/RP0/CPU0:router(config)#class-map map1
RP/0/RP0/CPU0:router(config-cmap)# match atm oam
Related Commands
DescriptionCommand
Defines a traffic class and the associated rules that match packets
to the class.
class-map, on page 12
Identifies a specified access control list (ACL) number as the match
criteria for a class map.
match access-group, on page 32
Identifies specified class of service (CoS) values as a match criteria
in a class map.
match cos, on page 36
Identifies specific IP differentiated services code point (DSCP)
values as match criteria for a class map.
match dscp, on page 44
Identifies specific three-bit experimental (EXP) field values in the
topmost Multiprotocol Label Switching (MPLS) label as match
criteria for a class map.
match mpls experimental topmost, on
page 48
Identifies IP precedence values as match criteria.match precedence, on page 50
Identifies specific quality-of-service (QoS) group values as match
criteria in a class map.
match qos-group, on page 56
Identifies a specific source MAC address as match criterion in a
class map.
match source-address, on page 58
Identifies selected VLAN IDs as the match criteria for a class map.match vlan, on page 60
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 35
Quality of Service Commands on the Cisco IOS XR Software
match atm