EasyManuals Logo

Cisco CRS Command Reference Guide

Cisco CRS
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
RP/0/RP0/CPU0:router(config-subif)#dot1q vlan 2 3
RP/0/RP0/CPU0:router(config-subif)#service-policy input 2
RP/0/RP0/CPU0:router(config-subif)#
Related Commands
DescriptionCommand
Defines a traffic class and the associated rules that match packets to
the class.
class-map, on page 12
Identifies a specified access control list (ACL) number as the match
criteria for a class map.
match access-group, on page 32
Enables packet matching on the basis of the ATM operations,
administration, and maintenance (OAM) or cell loss priority (CLP).
match atm, on page 34
Identifies a specific destination MAC address explicitly as a match
criterion in a class map.
match destination-address, on page 39
Identifies specific discard class values as a match criteria for a class
map.
match discard-class, on page 41
Identifies specific IP differentiated services code point (DSCP)
values as match criteria for a class map.
match dscp, on page 44
Identifies specific three-bit experimental (EXP) field values in the
topmost Multiprotocol Label Switching (MPLS) label as match
criteria for a class map.
match mpls experimental topmost, on
page 48
Identifies IP precedence values as match criteria.match precedence, on page 50
Identifies a specific protocol as the match criterion for a class map.match protocol, on page 53
Identifies specific quality-of-service (QoS) group values as match
criteria in a class map.
match qos-group, on page 56
Identifies a specific source MAC address as match criterion in a
class map.
match source-address, on page 58
Identifies selected VLAN IDs as the match criteria for a class map.match vlan, on page 60
Creates or modifies a policy map that can be attached to one or more
interfaces to specify a service policy.
policy-map, on page 67
Sets the Layer 2 class of service (CoS) value of an outgoing packet.set cos, on page 97
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
38 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
match cos

Other manuals for Cisco CRS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS and is the answer not in the manual?

Cisco CRS Specifications

General IconGeneral
Operating SystemCisco IOS XR
Product TypeCore Router
Form FactorModular Chassis
DimensionsVaries by chassis type
WeightVaries by chassis type
ArchitectureDistributed
Switch FabricMulti-stage
Interface SupportEthernet, SONET/SDH, OTN
Interfaces/PortsVaries by line card
Port DensityVaries by line card
Routing ProtocolBGP, IS-IS, OSPF, MPLS
ManagementCLI, SNMP
Power SupplyRedundant, hot-swappable
CoolingRedundant, Hot-swappable Fan Trays
Supported ProtocolsIPv4, IPv6, MPLS
Management InterfacesEthernet, console
Security FeaturesACLs

Related product manuals