EasyManuals Logo

Cisco GRS User Manual

Cisco GRS
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
100.1.1.0/24 serviceapp 3
200.1.1.0/24 serviceapp 3
!
Configuring ACL for a Infrastructure Service Virtual Interface: Example
In the following example output, the IP address 1.1.1.1 is used by the SVI on the MSC side and IP address
1.1.1.2 is used in the CGSE PLIM.
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# ipv4 access-list ServiceInfraFilter
RP/0/RP0/CPU0:router(config)# 100 permit ipv4 host 1.1.1.1 any
RP/0/RP0/CPU0:router(config)# 101 permit ipv4 host 1.1.1.2 any
RP/0/RP0/CPU0:router(config)# interface ServiceInfra1
RP/0/RP0/CPU0:router(config-if)# ipv4 address 1.1.1.1 255.255.255.192 service-location
0/1/CPU0
RP/0/RP0/CPU0:router(config-if)# ipv4 access-group ServiceInfraFilter egress
Use the show controllers services boot-params command to verify the IP addresses of SVI and
the CGSE PLIM.
RP/0/RP0/CPU0:router# show controllers services boot-params location 0/1/CPU0
=============================================
Boot Params
=============================================
Phase of implmentation : 1
Application : CGN
MSC ipv4 addddress : 1.1.1.1
Octeon ipv4 addddress : 1.1.1.2
ipv4netmask : 255.255.255.252
NAT44 Configuration: Example
This example shows a NAT44 sample configuration:
IPv4: 40.22.22.22/16
!
interface Loopback40
description IPv4 Host for NAT44
ipv4 address 40.22.22.22 255.255.0.0
!
interface Loopback41
description IPv4 Host for NAT44
ipv4 address 41.22.22.22 255.255.0.0
!
interface GigabitEthernet0/3/0/0.1
description Connected to P2_CRS-8 GE 0/6/5/0.1
ipv4 address 10.222.5.22 255.255.255.0
dot1q vlan 1
!
router static
address-family ipv4 unicast
180.1.0.0/16 10.222.5.2
181.1.0.0/16 10.222.5.2
!
!
Hardware Configuration for CSGE:
!
vrf InsideCustomer1
address-family ipv4 unicast
!
!
vrf OutsideCustomer1
address-family ipv4 unicast
!
Cisco IOS XR Carrier Grade NAT Configuration Guide for the Cisco CRS Router, Release 5.2.x
86 OL-32659-01
Implementing Carrier Grade NAT on Cisco IOS XR Software
Configuring ACL for a Infrastructure Service Virtual Interface: Example

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco GRS and is the answer not in the manual?

Cisco GRS Specifications

General IconGeneral
BrandCisco
ModelGRS
CategoryNetwork Router
LanguageEnglish

Related product manuals