Cisco IOS XE Intelligent Services User Manual

Configuring ISG Accounting
How to Configure ISG Accounting
19
Attribute list:
1A1CADF0 0 00000001 session-id(361) 4 167(A7)
1A1CAE00 0 00000001 protocol(297) 4 ip
1A1CAE10 0 00000001 addr(8) 4 192.168.0.1
1A1CAE20 0 00000001 Framed-Protocol(101) 4 PPP
1A1CAE30 0 00000009 clid-mac-addr(37) 6 00 00 04 00 00 2A
--------
No data for type CMD
No data for type SYSTEM
No data for type RM CALL
No data for type RM VPDN
No data for type AUTH PROXY
No data for type 8
No data for type CALL
No data for type VPDN-TUNNEL
No data for type VPDN-TUNNEL-LINK
No data for type 12
No data for type IPSEC-TUNNEL
No data for type RESOURCE
No data for type 15
Debg: No data available
Radi: No data available
Interface:
TTY Num = -1
Stop Received = 0
Byte/Packet Counts till Call Start:
Start Bytes In = 0 Start Bytes Out = 0
Start Paks In = 0 Start Paks Out = 0
Byte/Packet Counts till Service Up:
Pre Bytes In = 0 Pre Bytes Out = 0
Pre Paks In = 0 Pre Paks Out = 0
Cumulative Byte/Packet Counts :
Bytes In = 11434660 Bytes Out = 0
Paks In = 92215 Paks Out = 0
StartTime = 12:02:40 IST Oct 16 2007
AuthenTime = 12:02:40 IST Oct 16 2007
Component = IEDGE_ACCOUNTING
Authen: service=NONE type=NONE method=RADIUS
Kerb: No data available
Meth: No data available
Preauth: No Preauth data.
General:
Unique Id = 00000097
Session Id = 000000A7
Attribute List:
1A1CADF0 0 00000001 port-type(198) 4 PPPoE over VLAN
1A1CAE00 0 00000009 interface(194) 7 4/0/0/2
PerU: No data available
Display Information About ISG Postpaid Tariff Switching
Use the show sss session command to display information about ISG postpaid tariff switching.
SUMMARY STEPS
1. enable
2. show sss session

Cisco IOS XE Intelligent Services Specifications

General

Brand	Cisco
Model	IOS XE Intelligent Services
Category	Gateway
Language	English