Cisco IOS XE Intelligent Services User Manual

Configuring ISG Access for PPP Sessions
How to Configure ISG Access for PPP Sessions Using Control Policies
8
Step 3
debug condition condition
Example:
Router# debug condition username user5@isp.com
Filters debug output on the basis of the specified condition.
Note See the module “Troubleshooting ISG with Session
Monitoring and Distributed Conditional
Debugging” for information about conditional
debugging.
Step 4
debug subscriber packet [event | full | detail]
Example:
Router# debug subscriber packet event
Displays diagnostic information about packets during
Subscriber Service Switch (SSS) call setup.
Step 5
debug subscriber error
Example:
Router# debug subscriber error
Displays diagnostic information about errors that can occur
during SSS call setup.
Step 6
debug subscriber event
Example:
Router# debug subscriber event
Displays diagnostic information about SSS call setup
events.
Step 7
debug subscriber fsm
Example:
Router# debug subscriber fsm
Displays diagnostic information about the SSS call setup
state.
Step 8
debug ppp {packet | negotiation | error |
authentication | subscriber switch}
Example:
Router# debug ppp packet
Displays information on traffic and exchanges in an
internetwork that is implementing the PPP.
Command or Action Purpose

Cisco IOS XE Intelligent Services Specifications

General

Brand	Cisco
Model	IOS XE Intelligent Services
Category	Gateway
Language	English