Cisco IP Phone

5-35
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-23091-01
Chapter 5 Configuring Features, Templates, Services, and Users
Enabling EnergyWise on the Cisco Unified IP Phone
Step 4 Set the HTTPS Service parameter to https only.
Step 5 Click Save.
Configuring UCR 2008 in Common Phone Profile
Use the following procedure to set the following UCR 2008 parameters:
• FIPS Mode
• SSH Access
• 80-bit SRTCP
Step 1 Choose Device > Device Settings > Common Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the SSH Access parameter to Disabled.
Step 4 Set the 80-bit SRTCP parameter to Enabled.
Step 5 Click Save.
Configuring UCR 2008 in Enterprise Phone Configuration
Use the following procedure to set the following UCR 2008 parameters:
• FIPS Mode
• HTTPS Server
• 80-bit SRTCP
Step 1 Choose Device > Device Settings > Common Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the HTTPS Server parameter to https only.
Step 4 Set the 80-bit SRTCP parameter to Enabled.
Step 5 Click Save.