Cisco ME 3400 - Page 150

2-124
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
ip arp inspection filter vlan
Examples This example shows how to apply the ARP ACL static-hosts to VLAN 1 for dynamic ARP inspection:
Switch(config)# ip arp inspection filter static-hosts vlan 1
You can verify your settings by entering the show ip arp inspection vlan 1 privileged EXEC command.
Related Commands Command Description
arp access-list Defines an ARP ACL.
deny (ARP access-list
configuration)
Denies an ARP packet based on matches against the DHCP bindings.
permit (ARP
access-list
configuration)
Permits an ARP packet based on matches against the DHCP bindings.
show arp access-list Displays detailed information about ARP access lists.
show ip arp inspection
vlan vlan-range
Displays the configuration and the operating state of dynamic ARP
inspection for the specified VLAN.