Cisco ME 3400 Command Reference Guide

2-51
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
clear rep counters
clear rep counters
Use the clear rep counters privileged EXEC command to clear Resilient Ethernet Protocol (REP)
counters for the specified interface or all interfaces.
clear rep counters [interface interface-id]
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Usage Guidelines You can clear all REP counters by using the clear rep counters command, or you can clear only the
counters for the interface by using the clear rep counters interface interface-id command.
When you enter the clear rep counters command, only the counters visible in the output of the show
interface rep detail command are cleared. SNMP visible counters are not cleared as they are read-only.
Examples This example shows how to clear all REP counters for all REP interfaces:
Switch# clear rep counters
You can verify that REP information was deleted by entering the show interfaces rep detail privileged
EXEC command.
Related Commands
interface interface-id (Optional) Specify a REP interface whose counters should be cleared.
Release Modification
12.2(46)SE This command was introduced.
Command Description
show interfaces rep detail Displays detailed REP configuration and status information.

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing