Cisco ME 3400 Command Reference Guide

A-16
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Appendix A Cisco ME 3400 Ethernet Access Switch Boot Loader Commands
rename
rename
Use the rename boot loader command to rename a file.
rename filesystem:/source-file-url filesystem:/destination-file-url
Syntax Description
Command Modes Boot loader
Command History
Usage Guidelines Filenames and directory names are case sensitive.
Directory names are limited to 45 characters between the slashes (/); the name cannot contain control
characters, spaces, deletes, slashes, quotes, semicolons, or colons.
Filenames are limited to 45 characters; the name cannot contain control characters, spaces, deletes,
slashes, quotes, semicolons, or colons.
Examples This example shows a file named config.text being renamed to config1.text:
switch: rename flash:config.text flash:config1.text
You can verify that the file was renamed by entering the dir filesystem: boot loader command.
Related Commands
filesystem: Alias for a flash file system. Use flash: for the system board flash device.
/source-file-url Original path (directory) and filename.
/destination-file-url New path (directory) and filename.
Release Modification
12.2(25)EX This command was introduced.
Command Description
copy Copies a file from a source to a destination.

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing