2-264
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
pagp port-priority
Examples This example shows how to set the port priority to 200:
Switch(config-if)# pagp port-priority 200
You can verify your setting by entering the show running-config privileged EXEC command or the
show pagp channel-group-number internal privileged EXEC command.
Related Commands Command Description
pagp learn-method Provides the ability to learn the source address of incoming packets.
show pagp Displays PAgP channel-group information.
show running-config Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_r
eference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
To Next Page
Loading...
