Cisco ME 3400 - Page 401

2-375
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
show dot1x
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
Dot1x Info for interface GigabitEthernet0/2
----------------------------------------------------
PortStatus = UNAUTHORIZED
MaxReq = 2
HostMode = Multi
Port Control = Auto
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
This is an example of output from the show dot1x interface interface-id privileged EXEC command:
Switch# show dot1x interface gigabitethernet0/1
Supplicant MAC 00d0.b71b.35de
AuthSM State = AUTHENTICATED
BendSM State = IDLE
PortStatus = AUTHORIZED
MaxReq = 2
HostMode = Single
Port Control = Auto
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
This is an example of output from the show dot1x statistics interface interface-id command. Table 2-11
describes the fields in the display.
Switch# show dot1x statistics interface gigabitethernet0/1
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 15 TxReq = 0 TxTotal = 15
RxStart = 4 RxLogoff = 0 RxRespId = 1 RxResp = 1
RxInvalid = 0 RxLenErr = 0 RxTotal= 6
RxVersion = 1 LastRxSrcMac 00d0.b71b.35de
Ta b l e 2-11 show dot1x statistics Field Descriptions
Field Description
TxReqId Number of Extensible Authentication Protocol (EAP)-request/identity frames
that have been sent.
TxReq Number of EAP-request frames (other than request/identity frames) that have
been sent.
TxTotal Number of Extensible Authentication Protocol over LAN (EAPOL) frames of any
type that have been sent.