2-16
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
arp access-list
Examples This example shows how to define an ARP access list and to permit both ARP requests and ARP
responses from a host with an IP address of 1.1.1.1 and a MAC address of 0000.0000.abcd:
Switch(config)# arp access-list static-hosts
Switch(config-arp-nacl)# permit ip host 1.1.1.1 mac host 00001.0000.abcd
Switch(config-arp-nacl)# end
You can verify your settings by entering the show arp access-list privileged EXEC command.
Related Commands Command Description
deny (ARP access-list
configuration)
Denies an ARP packet based on matches compared against the DHCP
bindings.
ip arp inspection filter
vlan
Permits ARP requests and responses from a host configured with a static IP
address.
permit (ARP
access-list
configuration)
Permits an ARP packet based on matches compared against the DHCP
bindings.
show arp access-list Displays detailed information about ARP access lists.
To Next Page
Loading...
