2-514
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
show spanning-tree
Command Modes User EXEC
Command History
Usage Guidelines STP is not supported on UNIs. Valid spanning-tree information is available only for NNIs or ENIs.
If the vlan-id variable is omitted, the command applies to the spanning-tree instance for all VLANs.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show spanning-tree active command:
Switch# show spanning-tree active
VLAN0001
Spanning tree enabled protocol ieee
Root ID Priority 32768
Address 0001.42e2.cdd0
Cost 3038
Port 24 (GigabitEthernet0/1)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 49153 (priority 49152 sys-id-ext 1)
Address 0003.fd63.9580
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Uplinkfast enabled
Interface Role Sts Cost Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Gi0/1 Root FWD 3019 128.24 P2p
<output truncated>
summary [totals] (Optional) Display a summary of port states or the total lines of the
spanning-tree state section.
vlan vlan-id [active
[detail] | backbonefast |
blockedports | bridge
[address | detail |
forward-time | hello-time |
id | max-age | priority
[system-id] | protocol]
(Optional) Display spanning-tree information for the specified VLAN
(some keywords available only in privileged EXEC mode). You can
specify a single VLAN identified by VLAN ID number, a range of
VLANs separated by a hyphen, or a series of VLANs separated by a
comma. The range is 1 to 4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)EX This command was introduced.
12.2(25)SEG The digest keyword was added, and new digest and transmit hold count
fields appear.
To Next Page
Loading...
