Cisco ME 3400 - Page 570

2-544
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
snmp-server enable traps
Note Though visible in the command-line help strings, the fru-ctrl insertion and removal, and vtp keywords
are not supported. The snmp-server enable informs global configuration command is not supported. To
enable the sending of SNMP inform notifications, use the snmp-server enable traps global
configuration command combined with the snmp-server host host-addr informs global configuration
command.
Defaults The sending of SNMP traps is disabled.
Command Modes Global configuration
port-security
[trap-rate value]
(Optional) Enable port security traps. Use the trap-rate keyword to set the
maximum number of port-security traps sent per second. The range is from
0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
port-security occurrence).
rtr (Optional) Enable SNMP Response Time Reporter traps.
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
(Optional) Enable SNMP traps. The keywords have these meanings:
• authentication—(Optional) Enable authentication trap.
• coldstart—(Optional) Enable cold-start trap.
• linkdown—(Optional) Enable linkdown trap.
• linkup—(Optional) Enable linkup trap.
• warmstart—(Optional) Enable warm-start trap.
storm-control
trap-rate value
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per minute. The range is from
0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every
storm-control occurrence).
stpx [inconsistency]
[root-inconsistency]
[loop-inconsistency]
(Optional) Enable SNMP STPX MIB traps. The keywords have these
meanings:
• inconsistency—(Optional) Enable SNMP STPX MIB inconsistency
update traps.
• root-inconsistency—(Optional) Enable SNMP STPX MIB root
inconsistency update traps.
• loop-inconsistency—(Optional) Enable SNMP STPX MIB loop
inconsistency update traps.
syslog (Optional) Enable SNMP syslog traps.
tty (Optional) Send TCP connection traps. This is enabled by default.
vlan-membership (Optional) Enable SNMP VLAN membership traps.
vlancreate (Optional) Enable SNMP VLAN-created traps.
vlandelete (Optional) Enable SNMP VLAN-deleted traps.