Cisco ME 3400 - Page 617

2-591
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
spanning-tree port-priority
This example shows how to set the port-priority value on VLANs 20 to 25:
Switch(config-if)# spanning-tree vlan 20-25 port-priority 0
You can verify your settings by entering the show spanning-tree interface interface-id privileged
EXEC command.
Related Commands Command Description
show spanning-tree interface
interface-id
Displays spanning-tree information for the specified interface.
spanning-tree cost Sets the path cost for spanning-tree calculations.
spanning-tree vlan priority Sets the switch priority for the specified spanning-tree instance.