EasyManua.ls Logo

Cisco ME 3400 - Page 83

Cisco ME 3400
872 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-57
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
conform-action
Command Modes Policy-map class police configuration
Command History
Usage Guidelines You can configure conform-action marking by using enhanced packet marking to modify a QoS marking
based on any incoming QoS marking and table maps. The switch also supports simultaneously marking
multiple QoS parameters for the same class and configuring conform-action marking and exceed-action
marking.
Access policy-map class police configuration mode by entering the police policy-map class command.
See the
police policy-map class configuration command for more information.
Use this command to set one or more conform actions for a traffic class.
Examples This example shows how configure multiple conform actions in a policy map that sets a committed
information rate of 23000 bits per second (bps) and a conform burst rate of 10000 bps. The policy map
includes multiple conform actions (for DSCP and for Layer 2 CoS) and an exceed action.
Switch(config)# policy-map map1
Switch(config-pmap)# class cos-set-1
Switch(config-pmap-c)# police cir 23000 bc 10000
Switch(config-pmap-c-police)# conform-action set-dscp-transmit 48
Switch(config-pmap-c-police)# conform-action set-cos-transmit 5
Switch(config-pmap-c-police)# exceed-action drop
Switch(config-pmap-c-police)# exit
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands
Release Modification
12.2(25)EX This command was introduced.
12.2(25)SEG Increased support for configuring conform-action marking. See “Usage
Guidelines.
Command Description
class Defines a traffic classification match criteria for the specified
class-map name.
exceed-action Defines the action to take on traffic that exceeds the CIR.
policy-map Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy.
police Defines a policer for classified traffic.
show policy-map Displays QoS policy maps.

Table of Contents

Other manuals for Cisco ME 3400

Related product manuals