Cisco Meraki MR18 - Mount the Mr

Mount the MR18
Attach the MR18 to the Mount Cradle
(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount
where you have already installed the mount cradle.)
The MR18 attaches to the mount cradle with two tabs on the cradle that insert into the MR18, and is secured to the
cradle using one screw.
To attach the MR18 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.
Since the cradle is already mounted to the wall, guide the MR18 towards the top tab and insert the top tab into the
MR18’s slot.
13