Cisco Meraki MR18 Installation Guide

Static IP via DHCP Reservations
Instead of associating to each Meraki AP individually to configure static IP addresses, an administrator can assign static
IP addresses on the upstream DHCP server. Through “DHCP reservations,” IP addresses are “reserved” for the MAC
addresses of the Meraki APs. Please consult the documentation for the DHCP server to configure DHCP reservations.
Collect Tools
You will need the following tools to perform an installation:
Collect Additional Hardware for Installation
You will need the following tools to perform an installation:
Installation Instructions
8

Cisco Meraki MR18 Specifications

General

Wireless Standards	802.11a/b/g/n
Frequency Bands	2.4 GHz and 5 GHz
MIMO	2x2
Power over Ethernet (PoE)	802.3af
Max Data Rate	600 Mbps
Operating Temperature	0°C to 40°C (32°F to 104°F)
Ethernet Ports	1 x 10/100/1000 Mbps
Antenna	Internal
Antenna Gain	2.4 GHz: 3 dBi, 5 GHz: 5 dBi
Power Method	PoE or 12V DC power adapter
Mounting	Wall, ceiling
Security	WPA2-Enterprise