Cisco Meraki MR52 - Powering the MR52 with Meraki AC Adapter

18
4.2.2.1 Powering the MR52 with the Meraki AC Adapter (sold separately)
1. Plug the power cord into the MR52 and the other end into a wall outlet.
2. Plug an Ethernet cable that is connected to an active Ethernet connection into the Eth0 port on the MR52.
4.2.2.2 Powering the MR52 with the Meraki 802.3at Power over Ethernet Injector (sold separately)
1. Plug the power cord into the PoE Injector and the other end into wall power.
2. Plug an Ethernet cable that is connected to an active Ethernet connection into the “IN“ port on the injector.
3. Route Ethernet cable from the “OUT“ port on the injector to the Eth0 port in the cable bay of the MR52.