Collect Additional Hardware for Installation
You will need the following tools to perform an installation:
• Network cables with RJ45 connectors long enough for your particular mounting location
• 802.3af PoE power source (either PoE switch or Meraki PoE Injector)
• Connection to the internet (if you are setting up your MR76 as a gateway to the internet)
• Appropriately sized metal straps (if mounting to a pole larger than 3.9” in diameter)
• Specialized mounting hardware if mounting to surface other than wood, stucco or stone
Installation Instructions
Warning: Due to the heat dissipation in the back of APs during normal operation, please do not stack powered on APs on top of each other during
pre-installation to avoid heat damage.
9
To Next Page
Loading...
